cracking_wpa
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
cracking_wpa [2010/03/07 16:09] – removed useless comment (it was updated for mac80211 some time ago) mister_x | cracking_wpa [2010/08/29 19:44] – Fixed channel/frequency graph link mister_x | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Tutorial: How to Crack WPA/WPA2 ====== | ====== Tutorial: How to Crack WPA/WPA2 ====== | ||
- | Version: 1.19 February 12, 2010\\ | + | Version: 1.20 March 07, 2010\\ |
By: darkAudax | By: darkAudax | ||
Line 147: | Line 147: | ||
In the response above, you can see that ath0 is in monitor mode, on the 2.452GHz frequency which is channel 9 and the Access Point shows the MAC address of your wireless card. Only the madwifi-ng drivers show the card MAC address in the AP field, other drivers do not. So everything is good. It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly. | In the response above, you can see that ath0 is in monitor mode, on the 2.452GHz frequency which is channel 9 and the Access Point shows the MAC address of your wireless card. Only the madwifi-ng drivers show the card MAC address in the AP field, other drivers do not. So everything is good. It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly. | ||
- | To match the frequency to the channel, check out: | + | To match the frequency to the channel, check out: http://www.cisco.com/en/US/ |
- | http://www.rflinx.com/help/calculations/# | + | |
=== Step 1b - Setting up mac80211 drivers === | === Step 1b - Setting up mac80211 drivers === |
cracking_wpa.txt · Last modified: 2022/01/02 21:34 by mister_x