rt2500
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
rt2500 [2008/05/03 00:21] – Clarify the status of the new driver netrolller3d | rt2500 [2009/06/01 18:19] – updated forum link mister_x | ||
---|---|---|---|
Line 12: | Line 12: | ||
modprobe rt2500 | modprobe rt2500 | ||
- | NOTE: This will download the Enhanced Legacy version of the driver. The Next Generation version | + | NOTE: This will download the Enhanced Legacy version of the driver. The Next Generation version |
Make sure to load the driver with modprobe (not insmod) and to put the card in Monitor mode before bringing the interface up. | Make sure to load the driver with modprobe (not insmod) and to put the card in Monitor mode before bringing the interface up. | ||
Line 22: | Line 22: | ||
The forceprism corrects the power being shown as " | The forceprism corrects the power being shown as " | ||
- | |||
- | |||
====== When to use this driver? ====== | ====== When to use this driver? ====== | ||
- | See this [[http:// | + | See this [[http:// |
If you have a Ralink chip in an USB device and that chip is a RT2570 or RT73 (RT73 is also known as RT2571 and RT2573), you need the " | If you have a Ralink chip in an USB device and that chip is a RT2570 or RT73 (RT73 is also known as RT2571 and RT2573), you need the " | ||
- | Using legacy drivers (or ASPj mods) interface name is ra0 for PCI/PCMCIA and rausb0 for USB devices, if you have wlan0 and wmaster0 interfaces, then you are using new rt2x00 driver (rt2x00 has various modules, for PCI devices are " | + | Using legacy drivers (or ASPj mods) interface name is ra0 for PCI/PCMCIA and rausb0 for USB devices, if you have wlan0 and wmaster0 interfaces, then you are using new rt2x00 driver (rt2x00 has various modules, for PCI devices |
rt2500.txt · Last modified: 2017/01/09 21:31 by mister_x